06.130.F141 Tile floor | Unbonded mortar bed over wood substrate

 

This detail shows ceramic tile on an unbonded mortar bed over a wood substrate. The mortar setting bed is separated from the wood with a cleavage membrane to allow the tile assembly to move independent of the structure. The tile may be fresh-set (i.e. the mortar bed is still workable) and adhered to the mortar with a cementitious bond coat, or the mortar bed may be allowed to cure before adhering the tile. If specified, a compatible waterproof membrane may be applied over the mortar bed if it is cured. The mortar bed is reinforced with a 2" x 2" galvanized wire mesh. Expansion joints in the floor assembly must be provided at locations shown by the design professional. This detail is based on the Tile Council of North America (TCNA) Handbook method F141.  Details that show different or modified concepts or methods can be of equal validity and should not be excluded from consideration. This detail shall not be used for construction without the approval an signature of a licensed design professional. The person using this detail shall be responsible for its complete design and proper application. 

Comments

Post a Comment

Popular posts from this blog

10.030.0633 Lintel rebuild | Terra cotta, extruded

This detail illustrates a modern rebuild strategy for replacing existing architectural terra cotta (TC) lintel, soffit, and accessory units around window openings. The existing TC is replaced with new extruded TC units, installed not filled, with weep holes at the underside of each overhanging unit; each secured with new stainless-steel anchorage. In restoring and rebuilding these types of historic wall systems, moisture mitigation is critical to their long-term preservation and performance. Moisture management measures in this detail include horizontal skyward-facing joint treatment of sealant or lead T-caps, and an integrated flashing system installed to protect existing structural steel. The flashing system includes a self-adhering flashing with ends dams secured by a termination bar with continuous sealant, a stainless-steel drip edge, and weeps in the vertical joints. Accessible existing structural steel is also protected by cleaning and coating with a corrosion-inhibiting co
Read more

10.030.0433 Sill and mullion rebuild | Terra cotta, extruded

This detail illustrates a modern rebuild strategy for replacing existing architectural terra cotta (TC) sill, mullion, and accessory units around window openings. The existing TC is replaced with new extruded TC units, installed not filled, with weep holes at the underside of each overhanging unit; each secured with new stainless-steel anchorage. In restoring and rebuilding these types of historic wall systems, moisture mitigation is critical to their long-term preservation and performance. Moisture management measures in this detail include horizontal skyward-facing joint treatment of sealant or lead T-caps, and an integrated flashing system beneath the sill. The flashing system includes a self-adhering flashing with ends dams secured by a termination bar with continuous sealant, a stainless-steel drip edge, and weeps in the vertical joints. The existing structural steel supports are also protected by cleaning and coating with a corrosion-inhibiting coating. These TC rebuild details
Read more

04.030.0202 Dimension stone wall, interior | Wire ties and molding plaster

     04.030.0202 Dimension stone wall, interior | Wire ties and molding plaster This detail shows 2 cm (3/4 in.) thick dimension stone anchored to an interior wall substrate with anchors of 8-gauge  (0.1285”) copper or stainless steel wire ties encapsulated by molding plaster at the perimeter of each stone panel. The wire is fitted into slightly oversized holes in edges of the stone panels, with wood plugs filling the space around the wire. The wire anchors are sized and spaced per empirical design and are fastened to the concrete masonry backing via holes cut into the block, also filled with plaster or rapid-curing cementitious material. Joints between the panels may be finished with compatible sealant and backer rod (not shown for clarity). This detail shall not be used for construction without the approval of a licensed design professional. The person using this detail shall be responsible for its complete design and proper application.
Read more